HP Proliant DL580 - Sliding the Server to the Rear of the Rack

Installing the Server in a Rack
5. Reach around the front of the server to press the rail-release levers at the front of
both server rails, and continue to slide the server into the rack.
Figure 8-9: Sliding the server to the rear of the rack
6. Once the server reaches the rear of the rack, slide it all the way back out of the
rack until the rack assembly is fully extended and the rails lock. This action
initializes the rail lock for future use.
7. Press the rack levers at the front of the server rails to release the lock, and slide
the server all the way back into the rack.
8-12 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Karen Hale File Name: i-ch8 Installing the Server in a Rack.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:41 AM