PCI-X Technology
Removing an Expansion Board
To remove an expansion board:
1. From the Main menu, highlight the slot and expansion board to be removed.
2. Press the Enter key to go to the Slot Options menu.
3. Use the arrow keys to highlight Remove Expansion Board and press the Enter
key. NCMCON then processes the remove request.
4. Be sure that the slot has a status of POWERED down and the green LED is no
longer illuminated.
5. Open the expansion slot latch.
6. Remove the expansion board from the slot. NCMCON updates the status of the
slot.
Replacing an Expansion Board
To replace an expansion board:
1. Remove the expansion board from the slot.
2. Be sure that the slot has a status of POWERED down and the green LED is not
illuminated.
3. Install the new expansion board in the slot.
4. Close the expansion slot latch.
5. When the new expansion board is detected, NCMCON automatically asks if you
want to configure and apply power to the slot:
— If you answer Yes, power is applied to the slot, the green LED illuminates,
and the status of the slot on the console changes to READY.
— If you answer No, the console status does not change.
6. Press the Enter key to go to the Slot Options menu.
7. Use the arrow keys to highlight Replace Adapter and press the Enter key.
NCMCON processes the replace request.
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide 7-25
HP CONFIDENTIAL
Writer: Karen Hale File Name: h-ch7 PCI-X Technology.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:38 AM
To Next Page
Loading...
