• YKDELETE
3. Use TPC-R on the primary host to restart the copying of the Cnt Ac-S copy pairs with the
HyperSwap attribute.
4. On the primary host, monitor the copy pair status transitions to the DUPLEX status of the Cnt
Ac-S copy pairs with the HyperSwap attribute.
• YKEWAIT GOTO(DUPLEX)
5. On the primary host, make Cnt Ac-J Z copy pairs that are in the HOLD status and that are
between the primary storage system and the remote storage system.
Using a 2DC configuration with HyperSwap and Continuous Access Journal Z 369
To Next Page
Loading...
