HPE ProLiant Gen9

Action
Move the PCI card to the correct slot. For more information, see the user guide on the Hewlett Packard
Enterprise website.
1500 Series
1500-iLO 4 configuration is temporarily unavailable
Symptom
1500-iLO 4 configuration is temporarily unavailable.
Cause
iLO is busy or unresponsive to the software that is running on the system.
Action
1. Reboot the iLO processor.
2. Update the iLO firmware.
3. Reset the iLO NVRAM.
For more information, see the user guide on the
Hewlett Packard Enterprise website.
1501-iLO 4 Security Override Switch is set
Symptom
1501-iLO 4 Security Override Switch is set. iLO 4 security is DISABLED!
Cause
The iLO security override switch is set to the ON position.
Action
Set the iLO security override switch to the OFF position.
To locate the system maintenance switch bank, see the user guide on the Hewlett Packard Enterprise
website.
1502-iLO 4 is disabled
Symptom
1502-iLO 4 is disabled. Use the Security Override Switch and iLO 4 F8 ROM-Based Setup Utility to enable
iLO functionality.
Cause
The iLO security override switch is set to the ON position.
Action
1. Set the iLO security override switch to the OFF position.
104 1500 Series