HPE ProLiant Gen9

envtools: Downgrading NVRAM version from 26 to 25.
envtools: Downgrading NVRAM version from 27 to 26.
envtools: Factory Settings Restored.
envtools: NVRAM downgraded from [value] to [value].
envtools: NVRAM downgraded to version [value]
envtools: Updating NVRAM version to 19.
envtools: Updating NVRAM version to 20.
envtools: Updating NVRAM version to 21.
envtools: Updating NVRAM version to 22.
envtools: Updating NVRAM version to 23.
envtools: Updating NVRAM version to 24.
envtools: Updating NVRAM version to 25.
envtools: Updating NVRAM version to 26.
envtools: Updating NVRAM version to 27.
envtools: Updating NVRAM version to 28.
envtools: Updating NVRAM version to 29.
Firmware flash log messages
Log type: LOG_ALERT, Failure type: SW
FWSync: OA firmware sync flash failed and system is in an unstable state. Do not
reboot! Try to flash again with a new image.
OA_Flash: Flash failed and system is in an unstable state. Do not reboot!Try to
flash again with a new image.
Log type: LOG_ERR, Failure type: SW
FWSync: Error opening OA firmware sync image.
FWSync: Error opening OA firmware sync image.
FWSync: Invalid flash image.
FWSync: OA firmware sync image is corrupted.
FWSync: OA firmware sync image is older than current firmware.
FWSync: Only one flash instance can run at a time.
FWSync: Only one instance of OA firmware sync can run at a time.
OA_Flash: Downloading flash image failed.
OA_Flash: Error opening [value] for input.
OA_Flash: Firmware image is corrupted or not a valid image. Please verify the
url and try again.
OA_Flash: Firmware version [value:version] is not supported on this hardware.
OA_Flash: Found core file. Reboot after flash suppressed to allow developer to
debug.
OA_Flash: Invalid flash image.
OA_Flash: Invalid flash image.
Firmware flash log messages 245