HPE ProLiant Gen9

Operational log messages
Log type: LOG_EMERG, Failure type: SW
OA: Internal System Firmware Error. Rebooting.
Log type: LOG_WARNING, Failure type: SW
FWSync: OA firmware sync failed to create firmware image from the Active Onboard
Administrator
FWSync: OA firmware sync failed to create firmware image from the Standby
Onboard Administrator
FWSync: OA firmware sync of the Active Onboard Administrator failed
FWSync: OA firmware sync of the Standby Onboard Administrator failed
OA: Active Onboard Administrator will not be flashed
OA: Consider resetting the Standby and/or Active Onboard Administrators and
retrying
OA: Failed flashing Standby Onboard Administrator
OA: Failed to copy firmware image to the Standby Onboard Administrator
OA: Failed to register for events on the Standby Onboard
Administrator(error=0x[value])
OA: Failed to send URB message to configured endpoint. Check URB settings.
OA: Firmware image corrupt. Please verify the image and retry
OA: Please inspect the system log on the Standby Onboard Administrator for
further details
OA: The Active and Standby Onboard Administrators may not be communicating
reliably
OA: The Onboard Administrator in bay %d has been reset via e-fuse by user
[value].
OA: LDAP Server Timed Out.
Log type: LOG_WARNING, Failure type: Info
FWSync: OA firmware sync initiated by user [value:username]
FWSync: Other (STANDBY) OA will be upgraded to firmware [value:versionNumber]
FWSync: This (ACTIVE) OA will be upgraded to firmware [value:versionNumber]
OA: Flashing Active Onboard Administrator. Initiated by user [value:username]
OA: Flashing Standby Onboard Administrator. Initiated by user [value:username]
Log type: LOG_CRIT, Failure type: SW
OA: Enclosure Name change failed.
OA: Failed NVRAM commit of Enclosure Dynamic Power Cap bay opt out list by
[value:username].
OA: Failed to reset the Onboard Administrator.
OA: Rack Name change failed
Log type: LOG_CRIT, Failure type: Info
Log cleared by [value:username].
250 Operational log messages