HPE ProLiant Gen9 - Page 249

OA: KVM Bay [value:bladeNumber] - Connecting to blade failed because the blade
is powered off.
OA: KVM Bay [value:bladeNumber] - Could not connect. Error([value]).
OA: KVM Bay [value:bladeNumber] - Could not connect. If error persists reboot
the OA.
OA: KVM Bay [value:bladeNumber] - Could not create thread.
OA: KVM Bay [value:bladeNumber] - Disconnected from blade. Bad getmore
OA: KVM Bay [value:bladeNumber] - Disconnected from blade. Bad next state
detected.
OA: KVM Bay [value:bladeNumber] - Disconnected from blade. Bad state transition
detected.
OA: KVM Bay [value:bladeNumber] - Disconnected from blade. Exit state detected.
OA: KVM Socket connect error [value] ([value]) to ILO addr [value:Address]:
[value:port]
OA: KVM Socket creation error [value] ([value]) to ILO addr[value:Address]
OA: Mutex SEMV post failed errno [value]
OA: Mutex SEMV wait failed errno [value]
OA: Screenshot Thread exiting....
OA: KVM Bay [value:bladeNumber] - Could not determine fips mode
OA: KVM Bay [value:bladeNumber] - Configure ILO to enforce AES Encryption in
FIPS mode.
OA: KVM - Could determine OA fips mode
OA: KVM Bay [value:bladeNumber] - ILO2 is not supported in FIPS MODE.
Log type: LOG_ERR, Failure type: Info
OA: KVM ([value:address]) Change ILO setting to enable 'acquire remote console'
failed.
OA: KVM Bay [value:bladeNumber] - Acquired console. Connected to blade.
OA: KVM Bay [value:bladeNumber] - Connecting to blade failed because the blade
is powered off.
OA: KVM Bay [value:bladeNumber] - Connecting to blade.
OA: KVM Bay [value:bladeNumber] - Console in use by another client.
OA: KVM Bay [value:bladeNumber] - Console is in use by another client and could
not be acquired.
OA: KVM Bay [value:bladeNumber] - Console session acquired by [value:OA user /
username] at [value:address]
OA: KVM Bay [value:bladeNumber] - Disconnected from blade due to app exit.
OA: KVM Bay [value:bladeNumber] - Disconnected from blade.
OA: KVM Bay [value:bladeNumber] - Must wait 5 minutes before attempting to
acquire the console.
OA: KVM Bay [value:bladeNumber] - Session acquired by different user.
OA: KVM Blade [value:bladeNumber] console session closed due to ILO firmware
upgrade
HPE Onboard Administrator errors 249