HPE ProLiant Gen9

Event log display Event log explanation
Update of Power Management Controller to version
[version number] complete
The Power Management Controller has been
successfully updated to the listed version.
User [user 1] added by [user 2] A user account was added.
User [user 1] deleted by [user 2] A user account was deleted.
User [user 1] modified by [user 2] A user account was modified.
Utility data center lock disabled by: [user name] The utility data center lock was disabled by the listed
user.
Utility data center lock enabled by: [user name] The utility data center lock was enabled by the listed
user.
Virtual media connected by: [user name] A virtual media device was connected by the listed
user.
Virtual media disconnected by: [user name] A virtual media device was disconnected by the
listed user.
Virtual NMI selected by: [user name] The virtual non-maskable interrupt was generated by
the listed user.
Virtual Serial Port started by: [user name] - [IP
address and DNS name]
Virtual Serial Port was started by the listed user from
the listed IP address and DNS name.
Virtual Serial Port stopped by: [user name] - [IP
address and DNS name]
Virtual Serial Port was stopped by the listed user
from the listed IP address and DNS name.
XML login failure from: [IP address and DNS name]. An attempt to login to iLO failed from the listed IP
address and DNS name, via the RIBCL interface.
XML login: [user name] - [IP address and DNS
name].
The listed user logged in to iLO via the RIBCL
interface from the listed IP address and DNS name.
XML logout: [user name] - [IP address and DNS
name].
The listed user logged out of iLO via the RIBCL
interface from the listed IP address and DNS name.
RIBCL messages
The following table lists the error messages displayed when using the RIBCL XML scripting language.
Status number Error message
0x0000
No error.
0x0001
Syntax error.
0x0002
This user is not logged in.
0x0003
Login name is too long.
0x0004
Password is too short.
0x0005
Password is too long.
0x0006
User table is full. No room for new
user.
0x0007
Cannot add user. The login/ user name
already exists.
Table Continued
RIBCL messages 311