HPE ProLiant Gen9

OA: dhcpRelease: sendto: [value]
OA: dhcpStart: bind: [value]
OA: dhcpStart: fcntl: [value]
OA: dhcpStart: interface [value] is not Ethernet or 802.2 Token Ring
OA: dhcpStart: ioctl SIOCGIFFLAGS: [value]
OA: dhcpStart: ioctl SIOCGIFHWADDR: [value]
OA: dhcpStart: ioctl SIOCSIFFLAGS: [value]
OA: dhcpStart: setsockopt: [value]
OA: dhcpStart: socket: [value]
OA: dhcpStop: ioctl SIOCSIFFLAGS: [value]
OA: error executing [value] [value] [value]: [value]
OA: mkdir([value]",0): [value]"
OA: recvfrom: [value]
OA: sendto: [value]
OA: Timed out waiting for a valid DHCP server response. Will keep trying in the
background
OA: writePidFile: fopen: [value]
DHCP Monitor: Could not start DHCPD for IPv4. Error: [value]
DHCP Monitor: Could not start DHCPD for IPv6. Error: [value]
DHCP Monitor: Could not stop dhcpd for [value]
DHCP Monitor: DHCPD is not running. Restarting OA.
Log type: LOG_NOTICE, Failure type: SW
OA: Got IP lease: address = [address]
Log type: LOG_INFO, Failure type: SW
OA: infinite IP address lease time. Exiting
Enclosure-Link log messages
Log type: LOG_WARNING, Failure type: SW
OA: Enclosure Link Daemon could not register for events.
Log type: LOG_CRIT, Failure type: SW
Enclosure-Link: Could not acquire bottom enclosure's UUID. Cannot set RUID.
Enclosure-Link: Failed to read topology
Enclosure-Link: Got unexpected error from socket: [value]
Enclosure-Link: RUID recovered: [value]
Log type: LOG_ERR, Failure type: SW
Enclosure-Link: [value] enclosure(s) seen on Enclosure Link. Only
[value:Max_Enclosures] enclosure(s) supported. Please remove [value]
enclosure(s)
Enclosure-Link: Corrupted topology on eth2
242 Enclosure-Link log messages