HPE ProLiant Gen9

Redundancy: Failed automatic Onboard Administrator failover as a result of
network link loss on the Active OA board
Log type: LOG_ERR, Failure type: SW
Redundancy: Couldn't get random seed
Redundancy: Error communicating via ethernet with the other Onboard
Administrator (heartbeat).
Redundancy: Error communicating via ethernet with the other Onboard
Administrator (timeout).
Redundancy: Error communicating with the other Onboard Administrator.
Redundancy: Failed to get enclosure network
Redundancy: Failed to read OA bay number
Redundancy: Failed to read OA status
Redundancy: Other ([Standby/Active]) OA firmware: v[value:version] - This OA
([Standby/Active]) firmware: v[value:version]
Redundancy: Please upgrade to the latest firmware using [this/the other] Onboard
Administrator which is the active
Redundancy: WARNING: The other OA ([Standby/Active]) is running a different
firmware. OA Redundancy will be degraded
Log type: LOG_NOTICE, Failure type: SW
Redundancy: Assuming active Onboard Administrator network settings.
Redundancy: Enclosure IP mode was [disabled/enabled]
Log type: LOG_INFO, Failure type: SW
Redundancy: Enclosure IP mode configurations have been reset.
Redundancy: Onboard Administrator has now completed the Standby to Active
transition
Redundancy: Onboard Administrator redundancy restored.
Redundancy: Service started ([ACTIVE/STANDBY])
SSO log messages
Log type: LOG_WARNING, Failure type: Info
OA: SSO [value] logged into the Onboard Administrator
OA: SSO [value] logged into the Onboard Administrator from [value:remoteAddress]
Log type: LOG_NOTICE, Failure type: Info
OA: Authentication failure for user SSO [value]
OA: Authentication failure for user SSO [value] from [value:remoteAddress]
OA: SSO Trust Mode changed to [value] by user [value:username].
Two-factor log messages
Log type: LOG_WARNING, Failure type:SW
OA: Two Factor: Two-Factor authentication failed for user at [value]: local user
certificate status check failed.
SSO log messages 267