HPE ProLiant Gen9

Enclosure-Link: Got new TOPOLOGY event on enclosure [value:IpAddress]
Enclosure-Link: Initial topology scan completed successfully
Enclosure-Link: Service started
Non-volatile configuration log messages
Log type: LOG_WARNING, Failure type: SW
CLI: Error accessing User Configuration Files
Log type: LOG_ERR, Failure type: SW
envtools: Block [value] failed encoding
envtools: Error in default gateway
envtools: Error in DNS1 address
envtools: Error in DNS2 address
envtools: Error in ipaddress
envtools: Error in ipAllow1 address
envtools: Error in ipAllow2 address
envtools: Error in ipAllow3 address
envtools: Error in ipAllow4 address
envtools: Error in ipAllow5 address
envtools: Error in ipv6Dns1 address
envtools: Error in ipv6Dns2 address
envtools: Error in ipv6StaticAddress1 address
envtools: Error in ipv6StaticAddress2 address
envtools: Error in ipv6StaticAddress3 address
envtools: Error in netmask
envtools: Error: Administrator account was disabled and will be re-enabled upon
restart.
envtools: Error: Administrator account was missing, and will be re-created upon
restart. LPR required.
envtools: NVRAM write failed: [value]
DHCP Monitor: Error opening dhcpv6.conf for writing.
Log type: LOG_NOTICE, Failure type: SW
envtools: NVRAM block [value] failed check
envtools: NVRAM format could not be preserved.
envtools: NVRAM is unformatted or corrupted.
envtools: Warning: EBIPA has been disabled on device and interconnect bays.
Please check configuration after downgrade.
Log type: LOG_NOTICE, Failure type: Info
envtools: Downgrading NVRAM version from 24 to 23.
envtools: Downgrading NVRAM version from 25 to 24.
244 Non-volatile configuration log messages