HPE ProLiant Gen9

Procedure
1. Do one of the following:
• Press the F1 key to continue with logical drives disabled.
• Press the F2 key to accept data loss and re-enable logical drives.
2. Resolve any issues that disabled the drive.
3. If the drive is replaced, restore data from the backup.
Be sure the system is always powered up and down correctly:
• When powering up the system, all external storage systems must be powered up before (or at the same
time as) the server.
• When powering down the system, the server must be powered down before powering down any external
storage systems.
1783-Slot X Drive Array Controller Failure
Symptom
1783-Slot X Drive Array Controller Failure
(followed by one of the following:)
• [Board ID not programmed (replace ROMs or replace controller)]
• [I2C read error]
• [Image checksum error]
• [Inconsistent volume count2
• [Inconsistent volume count (B)]
• [Unexpected hardware revision – hardware rework needed]
• [Unsupported Flash ROM type installed]
• [iLO communication mechanism self-test error]
• [PROGRAM BUG! Insufficient padding bytes (cmd=##h)]
• [Incorrect EEPROM type]
• [Init failure (cmd=##h, err=##h)]
• [Command failure (cmd=##h, err=##h)]
• [Self-test failure (ErrCode=####h)]
• [I2C NVRAM reconfiguration failure]
• [PCI bridge missing]
• [PCI bridge disabled; check System ROM version]
• [PDPI not found]
142 1783-Slot X Drive Array Controller Failure