HPE ProLiant Gen9

1. Reseat the I/O modules.
2. Reseat the I/O module cables.
3. Replace the cables, if damaged.
4. If the issue persists, replace the I/O modules.
Installed drives not detected, only I/O module 2 present
1. Reseat the I/O modules.
2. Reseat the I/O module cables.
3. Replace cables, if damaged.
4. If the issue persists, replace I/O module 1.
1778-Slot X Drive Array resuming Automatic Data Recovery (Rebuild) process
Symptom
1778-Slot X Drive Array resuming Automatic Data Recovery (Rebuild) process.
Cause
A controller reset or power cycle occurred while Automatic Data Recovery was in progress.
Action
No action is required.
1779-Slot X Drive Array – Logical drive(s) previously failed
Symptom
1779-Slot X Drive Array – Logical drive(s) previously failed.
Select "F1" to continue with logical drives disabled
Select "F2" to accept data loss and to re-enable logical drives
(Followed by one of the following:)
• Logical drive(s) disabled due to possible data loss.
• Logical drive(s) reenabled.
Restore data from backup if replacement drive(s) have been installed.
Cause
• Previously failed logical drives are attached to the controller.
• The system was not powered up or down correctly.
Action
1778-Slot X Drive Array resuming Automatic Data Recovery (Rebuild)
process 141