HPE ProLiant Gen9

OA: Blade #[value:bladeNumber] boot order settings changed by user
[value:username].
OA: Blade #[value:bladeNumber] boot order settings changed by user
[value:username]. First Boot Device: [value]. Boot Agent: [value].
OA: Blade [value:bladeNumber] DVD connection changed by user [value:username] to
'[value:URL]'.
OA: Cold Boot virtual command enacted on blade[value:bladeNumber] by user
[value:username].
OA: Interconnect module [value:number] has been reset by user [value:username].
OA: Momentary Press virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Onboard Administrator in bay [value:bayNumber] was restarted by user
[value:username].
OA: Power limit was set to [value] by user [value:username]
OA: Power savings mode was set to [ON/OFF] by user [value:username]
OA: Power subsystem redundancy mode was set to [value] by user [value:username]
OA: Press and Hold virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Reboot virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Session on interconnect [value:bayNumber] cleared by [value]
OA: Standby Onboard Administrator flashed successfully
OA: Virtual power command enacted on interconnect [value:number] by user
[value:username]
OA: Warning: Not all VC-Enet modules are on the same VLAN ID
Log type: LOG_ERR, Failure type: Info
OA: Not possible to get the actual VC Mode of the enclosure.
Linux log messages
Log type: LOG_NOTICE, Failure type: Info
OA: Authentication failure for user [username] from [remote host] requesting
[value]
OA: Authentication failure for user [username] from Enclosure Link requesting
[value]
OA: Authentication failure for user [username] on [value].
OA: Authentication failure for user [username] on the OA KVM.
OA: Authentication failure for user [username] on the OA serial console.
OA: Authentication failure for user [username] requesting [value]
Management log messages
Log type: LOG_EMERG, Failure type: SW
OA: Internal System Firmware Error, Rebooting.
Linux log messages 257