HPE ProLiant Gen9

Log type: LOG_WARNING, Failure type: HW
OA: A port mismatch was found with server blade bay [value:bladeNumber] and
interconnect bay [value:slotNumber]
OA: Temperature of I/O module in slot [value:slotNumber] is at alert level
Log type: LOG_WARNING, Failure type: SW
OA: iLO in bay [value] has not responded to the previous [value:count] capping
requests from the Enclosure Dynamic Power Cap.
Log type: LOG_CRIT, Failure type: HW
OA Tray firmware upgrade failed.
OA: Blade in bay [value:bladeNumber] contains an unsupported #[value] mezz card.
OA: Enclosure Status changed from [N/A/Unknown/OK/Degraded/Failed] to [N/A/
Unknown/OK/Degraded/Failed].
OA: Failed to initialize key components. Please call support immediately.
OA: Fan [value] firmware upgrade failed.
OA: Interconnect [value:slotNumber] firmware upgrade failed.
OA: Interconnect [value] firmware upgrade failed.
OA: LCD fails to respond to keystrokes.
OA: LCD firmware upgrade failed.
OA: LCD not functioning properly, pausing operation for 10 seconds.
OA: LCD Status is: Failed
OA: mgmt: GPIO initialization failed.
OA: mgmt: i2c initialization failed.
OA: Mismatching I/O was detected on Blade [value:bladeNumber], interconnect
[value].
OA: Mismatching I/O was detected on Blade [value:bladeNumber], Mezzanine Card
[value], Port [value].
OA: Mismatching I/O was detected on Interconnect [value], Port [value].
OA: Temperature of I/O module in slot [value:slotNumber] is critical - module
shut down
OA: Unsupported Device in bay #[value:bladeNumber].
OA: Unsupported IO Module in bay #[value:slotNumber].
OA: Unsupported IO Module location in bay #[value:slotNumber].
Log type: LOG_CRIT, Failure type: SW
OA: Blade [value:bladeNumber] management processor firmware upgrade failed.
OA: Error reading Fru Board Info for the LCD.
OA: Error reading Fru information for the LCD.
OA: Error reading Fru Internal Use Area for the LCD.
OA: mgmt: Failed to acquire enclosure semaphore.
Log type: LOG_CRIT, Failure type: Info
258 HPE Onboard Administrator errors