HPE Smart Array errors
Controller runtime LEDs
To determine the controller status, see the appropriate controller-specific section.
P440ar controller LEDs
Immediately after you power up the server, the controller runtime LEDs illuminate briefly in a predetermined
pattern as part of the POST sequence. At all other times during server operation, the illumination pattern of
the runtime LEDs indicates the status of the controller.
Item Color Name Interpretation
1
Green Heartbeat
When the controller is in good health, this LED
flashes at 1 Hz. During power-up, this LED is
solid for up to 2 seconds.
2 Amber Fault When an error occurs, this LED is on. During
power-up, this LED is solid for up to 2 seconds.
3 Green Crypto
On = All attached volumes are encrypted.
Off = All attached volumes are plaintext.
Flashing = Both encrypted and plaintext
volumes are present.
4 Amber Debug
On = Controller is in reset state.
Off = Controller is in an idle or runtime state.
Flashing 5 Hz = Controller and cache are
performing a backup.
HPE Smart Array errors 167
To Next Page
Loading...
