569 IPv6 static route not found.
570 Invalid IPv6 static route destination. The route destination must be a valid IPv6 address.
571 All items cannot be disabled.
572 This action requires the OA to be in FIPS Mode ON/DEBUG.
573 Must set MINRATE option if using timeout range.
574 Minimum data rate must be larger than 0.
575 Maximum timeout must be larger than minimum timeout.
576 Timeout must be larger than 0.
577 HTTP Read Timeout is already set to the requested value.
Insight Display screen shot errors
1 Missing credentials.
2 The getLCDImage CGI process has caught the SIGSEGV signal.
3 Could not acquire access to the image in a reasonable amount of time.
4 Cannot open semaphores.
5 Produce SEMV does not work.
6 Consume SEMV does not work.
7 Cannot lock the image file.
8 Cannot open the image file.
9 Cannot seek in the image file.
10 Unable to resume session.
11 Insufficient privileges.
SysLog messages
These messages are sent to the Onboard Administrator System Log and can be viewed using the various
interfaces to the Onboard Administrator.
The types of system log messages are defined as follows:
• LOG_EMERG—system is unusable
• LOG_ALERT—action must be taken immediately
• LOG_CRIT—critical conditions
• LOG_ERR—error conditions
• LOG_WARNING—warning conditions
• LOG_NOTICE—normal but significant condition
• LOG_INFO—informational
Alertmail log messages
Log type: LOG_ERR, Failure type: SW
Alertmail: Calculated invalid enclosure count for topology event
SysLog messages 239
To Next Page
Loading...
