521 User has reached half the maximum allowed HP Passport login authentication failures. Please verify your
username and password are correct and retry registration.
522 HP Passport password has expired. Please update your password and retry registration.
523 User has at least one of the HP Passport required on-line identity elements missing. Please update your
HP Passport profile and retry registration.
524 HP Passport Security Q and A is not compliant; the user must enter a new security Q and A upon login.
Please update your HP Passport security Q and A and retry registration.
525 HP Passport password entered is incorrect. Please retry registration using the correct password.
526 HP Passport user has been added to a group. Please reset your password and retry registration.
527 User must enter an HP Passport security Q and A and change password. Please update your security Q
and A, update your password, and retry registration.
528 Protocol error occurred while communicating with the Insight Remote Support receiver.
529 Failed to resolve proxy. Please verify DNS settings, proxy settings and connectivity.
530 Failed to connect to the Insight Remote Support hosting server. Please verify Insight Remote Support
host and port information.
531 Failed to connect to the Insight Remote Support direct connect web service. Please verify DNS settings,
proxy settings and connectivity.
532 Remote Support receiver protocol error.
533 The setting cannot be cleared when user domain name is enabled.
534 The operation cannot be performed while Enclosure Firmware Management is enabled.
535 Invalid SNMP Engine ID string. The Engine ID string must contain 1 to 27 printable characters.
536 The password is too short.
537 The password is too long.
538 Error installing the certificate.
539 Enclosure IP mode requires the active Onboard Administrator to have a static IPv4 address or a static
IPv6 address. If IPv6 is not enabled, only the static IPv4 address can be used.
540 Configure a static IPv6 address for your active OA or disable Enclosure IP Mode before enabling DHCP
for IPv4.
541 Configure a static IPv4 address for your active OA or disable Enclosure IP Mode before disabling IPv6.
542 The submitted URL is invalid for uploading.
543 This version of Onboard Administrator firmware does not support boot options for servers configured in
UEFI Boot mode.
561 Transmission from the Insight Remote Support receiver was unsuccessful.
562 Transmission from the Insight Remote Support receiver was unsuccessful. Please check connectivity
between OA and the Insight Remote Support receiver.
563 The key strength for the provided key is invalid for this configuration.
564 This command is not supported by the interconnect.
565 The string entered is a link-local address and cannot be used for assignment.
566 Invalid IPv6 static route gateway. Route gateway must not be empty and must not contain prefix length.
567 IPv6 static route destination already exists.
568 Unable to add IPv6 route. The maximum number of IPV6 static routes already exist.
238 HPE Onboard Administrator errors
To Next Page
Loading...
