EasyManua.ls Logo

HPE ProLiant Gen9 - Page 237

HPE ProLiant Gen9
460 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
474 Failed to connect to Insight Remote Support direct connect web service. Please verify DNS settings,
proxy settings and connectivity.
475 Dynamic DNS is not enabled.
476 Invalid SNMP Engine ID. The Engine ID must start with '0x' followed by an even number of up to 64
hexadecimal digits.
477 Invalid Authentication Protocol.
478 Invalid Authentication Password, must contain 8 to 40 printable characters.
479 Invalid Privacy Protocol.
480 Invalid Privacy Password, must contain 8 to 40 printable characters.
481 Duplicate user, a SNMP user by this name and engine id already exists.
482 Invalid minimal security setting.
483 Invalid security setting.
484 Selected algorithm cannot be used while FIPS Mode is enabled.
485 A user with read-write access cannot be created while FIPS Mode is enabled.
486 You cannot use a remote engine id with a trap.
487 You cannot use the local engine id with an inform.
489 Error adding the language pack.
490 Error removing the language pack.
491 The file provided is not a valid Onboard Administrator language pack image.
492 Cannot remove the English language pack.
493 The language support pack is not installed.
494 The submitted file is not a valid SSH key.
499 The firmware image provided doesn't meet the VC Minimum Firmware Version requirement. Check the
OA Syslog for more details.
500 The action did not complete successfully.
502 Invalid response. No connection or network busy.
503 Web server busy or in service.
510 Remote Support services are provided by other solution.
511 DHCP-Supplied Domain Name cannot be disabled when the user-supplied domain name is not set.
512 The text must contain at least one visible character.
514 User ID is a required field. Please retry registration.
515 The user must have an active authenticated session. Please retry registration.
516 HP Passport system failure occurred. A problem has been detected in the HP Passport system. Please
retry later.
517 The session token is invalid due to any of the following reasons: failed decoding, token is null or empty,
userId is empty or session start value is not a number. Please retry registration.
518 Password is required. Please retry registration.
519 HP Passport user ID is invalid. Please retry registration with a valid user ID.
520 HP Passport account is locked out due to excessive login authentication failures. Please reset your
password and retry registration.
HPE Onboard Administrator errors 237

Table of Contents

Other manuals for HPE ProLiant Gen9

Related product manuals