HPE ProLiant Gen9

• All of the uplink ports associated with the network are unlinked.
• The user disables all the uplink ports associated with a non-shared network.
• The user disables all the uplink ports in a shared uplink set associated with a shared network.
Action:
• Connect the uplink ports.
• Enable the uplink ports associated with a non-shared network.
• Enable the uplink ports in a shared uplink set associated with a shared network.
7014 - Enet Network state DISABLED
Severity: MAJOR
Description: A network has been administratively disabled.
Possible cause: A user disabled a network through the UI.
Action: Enable the network through the UI.
FC Fabric events (8000-8999)
8012 - FC Fabric state FAILED
Severity: CRITICAL
Description: The VC fabric lost all uplink connectivity because of lack of configured ports or all configured
ports are in a bad state.
Possible causes:
• The VC fabric has no configured ports. The user removed all the uplink ports from the fabric.
• ALL VC fabric ports are in one of the following states:
◦ FAILED (hardware error), UNAVAILABLE (not logged in), DISABLED, UNKNOWN (FC module NO-
COMM).
◦ There is no uplink that is in DEGRADED or OK state.
Action: Configure the uplink ports.
Unknown Module events (9000-9999)
9012 - Unknown Module state FAILED
Severity: CRITICAL
Description: An unknown module has been labeled with a FAILED status. This status is usually indicated by
the OA after a module hot-plug insert operation or when VCM is starting up. This condition is usually fatal.
Possible cause: A hardware failure or corrupted firmware.
Action:
7014 - Enet Network state DISABLED 297