HPE ProLiant Gen9

• sysName
• cpqHoTrapFlags
• cpqSsBoxTempStatus
Supporting SNMP Trap Description: “Storage System temperature ok.”
Event identifier: cpqstmsg.dll - 1098 (Hex)0x4435044a (Service Event)
Log Severity: Information (1)
Log Message: Drive Array Physical Drive Monitoring is not enabled. The physical drive in slot %4, port %5,
bay %6 with serial number “%7”, does not have drive threshold monitoring enabled.
Event Identifiers 1101-1199
NT Event ID: 1101 (Hex)0x8435044d (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: Storage System Side Panel Removed.
Log Message: The side panel has been removed on the %6 %7 storage system connected to SCSI bus %5 of
the controller in slot %4.
SNMP Trap: cpqSs3SidePanelRemoved - 8013 in CPQSTSYS.MIB
Symptom: Storage System side panel is removed. The side panel status has been set to removed. The
storage system's side panel is not in a properly installed state. This situation may result in improper cooling of
the drives in the storage system due to air flow changes caused by the missing side panel.
User Action: Replace the storage system side panel.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqSsBoxSidePanelStatus
Supporting SNMP Trap Description: “Side panel is removed from unit.”
NT Event ID: 1102 (Hex)0x4435044e (cpqstmsg.dll)
Log Severity: Information (1)
Event Title: Storage System Side Panel In Place.
Log Message: The side panel has been replaced on the %6 %7 storage system connected to SCSI bus %5 of
the controller in slot %4.
SNMP Trap: cpqSs3SidePanelInPlace - 8012 in CPQSTSYS.MIB
Symptom: Storage System side panel is in place. The side panel status has been set to in place. The storage
system's side panel has returned to a properly installed state.
User Action: None.
Supporting SNMP Trap Data:
348 Event Identifiers 1101-1199