HPE ProLiant Gen9

HPE Insight Management Agents for Servers for
Windows
Event log messages associated with SNMP traps
This section contains a listing of the Microsoft Windows Server Event Log messages associated with SNMP
traps, which are generated by the HPE Insight Management Agents for Servers for Windows. Each event
entry has the corresponding SNMP trap number used by the agents.
Other information on the events in this section includes:
• Event Severity
• Event Message
• Event Message Source
• Event Symptom
• Supporting SNMP Trap Data
Windows NT
®
event log format
The following pages contain HPE Insight Management events that are entered into the Microsoft Windows NT
Event Log when they occur.
Values are of 32 bit, laid out as follows:
3 3 2 2 2 2 2 2 2 2 2 2 1 1 1 1 1 1 1 1 1 1
1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0
+----+---+—--+--------------------+--------------------------------------------+
|Sev | C|R | Facility | Code |
+----+--+-—-—+--------------------+------------------------------------------+
Where:
• Sev—The severity code
• 00—Success
• 01—Informational
• 10—Warning
• 11—Error
• C—The customer code flag
• R—A reserved bit
• Facility—The facility code (always “CPQ”)
• Code—The facility’s status code—the event number; the upper byte refers to the HPE Insight
Management Agent that served the event, the lower byte is the actual event number
HPE Insight Management Agents for Servers for Windows 319