HPE ProLiant Gen9

OA_Flash: Only one flash instance can run at a time.
OA_Flash: Out of memory while decoding flash image.
OA_Flash: The firmware image provided is older than the current firmware and OA
settings cannot be preserved. The force downgrade option must be used. Please
re-try with the force option to flash and go back to factory defaults.
Log type: LOG_NOTICE, Failure type: Info
FWSync: New firmware image flashed.
FWSync: OA firmware sync to [value:version] complete
OA_Flash: Firmware image flashed from [value:version] to [value:version]
Log type: LOG_INFO, Failure type: Info
OA_Flash: Image verified successfully and applies to this system using the
parameters supplied. Test Mode specified, skipping the actual flash process
Firmware version [value:version] ExitCode=0
Flash certificate, configuration, and storage log messages
Log type: LOG_ERR, Failure type: SW
CERTS: .ssh has wrong directory permissions
CERTS: [value] has wrong file permissions
CERTS: [value] has wrong permissions. Please reset to factory defaults
CERTS: authorized_keys2 has wrong file permissions
CERTS: dsaparam has wrong file permissions
CERTS: Failed to compute MD5
CERTS: Failed to open flash
CERTS: Failed to open input file
CERTS: Fail to open the file to be flashed
CERTS: Failed to open output file
CERTS: Failed to read data from flash
CERTS: Failed to read system files
CERTS: Failed to update system with new data
CERTS: Failed to write data to flash
CERTS: server.crt has wrong file permissions
CERTS: server.key has wrong file permissions
CERTS: ssh_host_dsa_key has wrong file permissions
CERTS: Tar file [value] is too big for flash [value]
CERTS: Wrong file permissions detected. Please reset to factory defaults
CERTS: Removing installed keys and certificates as part of setting factory
defaults
CERTS: Failed to create data
CERTS: Failed to locate data
CERTS: Capacity exceeded by [value] bytes
246 Flash certificate, configuration, and storage log messages