HPE ProLiant Gen9

sulogin: Normal startup
sulogin: System Maintenance Mode
CGI log messages
Log type: LOG_ERR, Failure type: SW
cdrom.iso: There was a problem reading from /dev/cdrom, however we cannot back
out now.
CLI log messages
Log type: LOG_WARNING, Failure type: Info
OA: [value] logged out of the Onboard Administrator
Log type: LOG_INFO, Failure type: Info
OA: ProLiant iLO firmware update attempted by user [value]
Interconnect bay log messages
Log type: LOG_WARNING, Failure type: Info
OA: [value] was connected to interconnect bay #[value]
OA: [value] was disconnected from interconnect bay #[value]
DHCP log messages
Log type: LOG_WARNING, Failure type: SW
OA: dhcpStart: retrying MAC address request (returned [value:MAC-Address]
DHCP Monitor: Arping thread did not get created properly: [value]
DHCP Monitor: Thread [value] did not get created properly: [value]
DHCP Monitor: Monitor thread for dhcpv4 did not get created properly: [value]
Log type: LOG_ERR, Failure type: SW
OA: arpCheck: recvfrom: [value]
OA: arpCheck: sendto: [value]
OA: arpInform: sendto: [value]
OA: arpRelease: sendto: [value]
OA: classIDsetup: uname: [value]
OA: DHCP_NAK server response received
OA: DHCP_NAK server response received: [value]
OA: dhcpConfig: fopen: [value]
OA: dhcpConfig: ioctl SIOCSIFADDR: [value]
OA: dhcpConfig: ioctl SIOCSIFBRDADDR: [value]
OA: dhcpConfig: ioctl SIOCSIFNETMASK: [value]
OA: dhcpConfig: open/write/close: [value]
OA: dhcpDecline: sendto: [value]
OA: dhcpInform: no IP address given
CGI log messages 241