Log Severity: Warning (2)
Log Message: The NIC Agent service detected an invalid state for agent *”%1”. The data contain the state.
Event identifier: cpqnimsg.dll - 292 (Hex)0x84350124 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not stop agent “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 293 (Hex)0x84350125 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not terminate agent “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 294 (Hex)0x84350126 (Service Event)
Log Severity: Warning (2)
Log Message: The NIC Agent service could not unload the module “%1”. The data contain the error code.
Event identifier: cpqnimsg.dll - 296 (Hex)0xc4350128 (Service Event)
Log Severity: Error (3)
Log Message: A driver for a NIC failed to open. This error can be caused by an improperly installed adapter.
Removing and reinstalling all adapters may correct the problem. The NIC Agent service will not respond to
any management requests.
Event identifier: cpqnimsg.dll - 297 (Hex)0x84350129 (Service Event)
Log Severity: Warning (2)
Log Message: An attempt to log an event to the IML failed. The IML log may be full. Clearing the IML log may
correct this problem.
Event identifier: cpqnimsg.dll - 298 (Hex)0xc435012a (Service Event)
Log Severity: Error (3)
Log Message: A fatal error occurred during Virus Throttle WMI event processing. Virus Throttle related traps
will not be sent.
Cause: WMI service is probably not running. Starting WMI service or NIC agent might solve this problem.
Event identifier: cpqnimsg.dll - 299 (Hex)0x8435012b (Service Event)
Log Severity: Warning (2)
Log Message: An attempt to query WMI for Virus Throttle event failed. The event data gives the error number.
Event Identifiers 300-1293
Event identifier: cpqnimsg.dll - 300 (Hex)0x8435012c (Service Event)
Log Severity: Warning (2)
Log Message: The WBEM query was cancelled by WMI. The query was issued again.
Cause: WMI service was probably restarted.
Event identifier: cpqnimsg.dll - 1024 (Hex)0x84350400 (Service Event)
Log Severity: Warning (2)
Log Message: The SNMP Insight Agent is unable to generate traps due to an error during initialization.
Cause: Check to Be sure that the SNMP service is running. Reinstalling the agents may fix this error.
Event identifier: cpqnimsg.dll - 1025 (Hex)0x84350401 (Service Event)
Log Severity: Warning (2)
Event Identifiers 300-1293 449
To Next Page
Loading...
