HPE ProLiant Gen9

HPE Virtual Connect errors
SNMP overview
SNMP is a protocol used by network management systems to monitor devices on a network. It works by
querying device objects, such as an interface status or port state. Virtual Connect supports SNMPv1,
SNMPv2, and SNMPv3.
SNMP consists of the following key components:
• SNMP managed devices
• SNMP agents
• SNMP management station
• MIBs
• SNMP traps
SNMP traps
A trap is an unsolicited notification sent from an agent to a management station when an event is detected. It
is the opposite of polling.
Traps can send device states or port statistics, such as throughput, errors, and discards.
The following table provides a summary of available SNMP traps.
Trap Category Severity MIB
cpqHoSWRunningStatusChangeTra
p
VCM Legacy Corresponds to the new
value of
cpqHoSWRunningStatus
CPQHOST-MIB
connUnitStatusChange VC-FC Other INFO FA-MIB
connUnitDeletedTrap VC-FC Other INFO FA-MIB
connUnitEventTrap VC-FC Other INFO FA-MIB
connUnitSensorStatusChange VC-FC Other CRITICAL FA-MIB
connUnitPortStatusChange VC-FC Port
Status
See table below FA-MIB
authenticationFailure
1
VC-FC Other CRITICAL SNMPv2-MIB
coldStart VC-FC Other CRITICAL SNMPv2-MIB
cpqHoSWRunningStatusChange VC-FC Other INFO CPQHOST-MIB
authenticationFailure VC-Enet
Other
CRITICAL SNMPv2-MIB
Domain status change (deprecated) — — —
vcDomainManagedStateChanged VCM Domain
Status
Corresponds to the name
of the new state
VCD-MIB
Table Continued
HPE Virtual Connect errors 273