OA: Trap Receiver [value:address] was added by user [value:username].
OA: Trap Receiver [value:address] was also added as alternative for IPv6 host.
OA: Trap Receiver [value:address] was deleted by user [value:username].
OA: Trusted Host [value:address] was added by user [value:username].
OA: Trusted Host [value:address] was deleted by user [value:username].
OA: Undoing VLAN IPCONFIG changes. IP mode is set to DHCP for OA #[value:number]
OA: Undoing VLAN IPCONFIG changes. IP mode is set to STATIC for OA
#[value:number]
OA: USB enable changed to [value]. Rebooting...
OA: User [value:username] privilege level was changed from [value:Administrator/
Operator/User/Anonymous] to [value:Administrator/Operator/User/Anonymous] by
user [value:username]. All web and CLI sessions (if any) were ended.
OA: User [value:username] was added by user [value:username].
OA: User [value:username] was assigned to group [value:groupname].
OA: User [value:username] was deleted by user [value:username].
OA: User [value:username] was disabled by user [value:username]. All web and CLI
sessions (if any) were ended.
OA: User [value:username] was enabled by user [value:username].
OA: User [value:username] was removed from group [value:groupname].
OA: User [value:username]'s contact was set removed by user [value:username].
OA: User [value:username]'s contact was set to [value] by user [value:username].
OA: User [value:username]'s full name was removed by user [value:username].
OA: User [value:username]'s full name was set to [value:fullname] by user
[value:username].
OA: VLAN IPCONFIG set to DHCP IP mode and VLAN ID [value] for OA #[value:number]
OA: VLAN IPCONFIG set to STATIC IP mode and VLAN ID [VALUE] for OA
#[value:number]
OA: VLAN setting has been restored to factory defaults
OA: VLAN setting has been reverted back to saved FLASH config data
OA: VLAN will be reverted to saved config data in [value] secs
OA: Removing VLAN [value:name] ID [value:number].
OA: Removing unnamed VLAN ID [value:number].
OA: Adding VLAN [value:name] ID [value:number].
OA: Adding unnamed VLAN ID [value:number].
OA: Changing VLAN ID [value:number] name to [value:name]
OA: Deleting VLAN ID [value:name].
OA: Waiting DHCPv4 server response.
Log type: LOG_INFO, Failure type: SW
OA: ERROR: Event [value] with location [value] sent
Log type: LOG_INFO, Failure type: Info
256 HPE Onboard Administrator errors
To Next Page
Loading...
