HPE ProLiant Gen9

OA: Link Loss Failover interval set to [value] seconds by user [value:username].
OA: Local user authentication was [Disabled/Enabled] by user [value:username].
OA: Name of Onboard Administrator [value:bayNumber] was changed to
[value:username].
OA: Network Interface link forced to [value:speed]Mbps - Full Duplex by user
[value:username].
OA: Network Interface link forced to [value:speed]Mbps - Half Duplex by user
[value:username].
OA: Network Interface link set to Auto negotiation by user [value:username].
OA: New SSH key installed by user [value:username]
OA: Nothing needs to be reverted as VLAN setting has not changed
OA: Polling Interval of NTP set to [value] seconds by user [value:username].
OA: PowerDelay has been initiated for the selected devices.
OA: PowerDelay has completed for the selected devices.
OA: PowerDelay interconnect settings have been changed by user [value:username].
OA: PowerDelay server settings have been changed by user [value:username].
OA: Primary NTP server was set to [value:ntp] by user [value:username].
OA: Protocol http was [enabled/disabled] by user [value:username]
OA: Protocol SSH was [enabled/disabled] by user [value:username]
OA: Protocol Telnet was [enabled/disabled] by user [value:username]
OA: Protocol XML was [enabled/disabled] by user [value:username]
OA: Rack Name was changed to [value] by user [value:username]
OA: Remote syslog test message.
OA: Remote system log address set to [value:Address]
OA: Remote system log port set to [value:port]
OA: Remote system logging enabled to server [value:Address], port [value:port]
OA: Remote system logging was disabled.
OA: Saving VLAN IPCONFIG changes
OA: Secondary NTP server was set to [value:ntp] by user [value:username].
OA: Secure Shell authorized key file added by [value]
OA: Secure Shell authorized key file cleared by [value]
OA: SNMP Contact set to [value] by user [value:username].
OA: SNMP Location set to [value] by user [value:username].
OA: SNMP ReadOnly community string set to [value] by user [value:username].
OA: SNMP ReadWrite community string set to [value] by user [value:username].
OA: Static TCP/IP settings was modified by user [value:username].
OA: TCP/IP settings was set to DHCP - DynamicDNS by user [value:username].
OA: TCP/IP settings was set to DHCP by user [value:username].
OA: Tcp timeout set to [value:number] minutes.
HPE Onboard Administrator errors 255