HPE ProLiant Gen9

OA: CA certificate (issuer = [value:issuer-CN]) installed by user
[value:username].
OA: CA certificate (issuer = [value:issuer-CN]) removed by user
[value:username].
OA: Certificate for user [value:username] installed by user [value:username].
OA: Certificate for user [value:username] removed by user [value:username]. All
web sessions (if any) were ended.
OA: Certificate owner field set to ([SAN/SUBJECT]) on Onboard Administrator by
user [value:username].
OA: Certificate Revocation check [enabled/disabled] on Onboard Administrator by
user [value:username].
OA: Downloaded SIM certificate by user [value:username]
OA: Enclosure Dynamic Power Cap bay opt out list set to [value] by
[value:username].
OA: Enclosure Dynamic Power Cap set to: [value], derated circuit [value], rated
circuit [value] by [value:username].
OA: Enclosure Dynamic Power Cap set to: OFF by [value:username].
OA: Enclosure part number changed from '[value]' to '[value]' by
[value:username].
OA: Enclosure PDU type changed from '[value]' to '[value]' by [value:username].
OA: Forced takeover requested by user [value:username].
OA: SSO certificate [value:subject-CN] added by user [value:username].
OA: SSO certificate [value] removed by user [value:username].
OA: LDAP Directory Server certificate(MD5=[value]) installed by user
[value:username].
OA: LDAP Directory Server certificate(MD5=[value]) removed by user
[value:username].
OA: Onboard Administrator [value:bayNumber] name change failed.
OA: Resetting the Onboard Administrator because two-factor authentication
configuration has changed.
OA: Self signed certificate generated and installed by user [value:username].
OA: Time changed by [value:username].
OA: Time zone changed by [value:username].
OA: Time zone changed from [value] to [value]
OA: Time zone changed to [value]
OA: Two Factor Authentication [enabled/disabled] on Onboard Administrator by
user [value:username].
Log type: LOG_NOTICE, Failure type: SW
FWSync: Sync failed because the Active and Standby OAs do not have the same
hardware version.
OA: unable to run [value:mount]
OA: Warning: Unable to ping the remote oa_syslog server [value:Address]
HPE Onboard Administrator errors 251