HPE ProLiant Gen9 - Page 191

Log message: SnapShot ID <ID number> of logical drive <logical drive number> on
<external specification> array controller <controller name / slot information>
has been disabled.
<external specification> values:
• “the external controller attached to”
• ""
Message Id: 24657
Severity: Informational
Log message: Performing a recovery for a restore operation on SnapShot ID <ID
number> for logical drive <logical drive number> on <external specification>
array controller <controller name / slot information>.
<external specification> values:
• “the external controller attached to”
• ""
Message Id: 24658
Severity: Informational
Log message: Restore operation started on Snapshot ID <ID number> of logical drive
<logical drive number> on <external specification> array controller <controller
name / slot information>.
<external specification> values:
• “the external controller attached to”
• ""
Message Id: 24659
Severity: Informational
Log message: Port <port number> of controller <controller name / slot information>
is reporting <PHY status> for PHY number <phy number>.
Message Id: 24660
Severity: Informational
Log message: Smart Array controller <controller name / slot information> has
reported that its partner controller has been <added to / removed from> the SAS
fabric.
Message Id: 24661
Severity: Informational
Log message: Surface analysis parity/consistency initialization forced complete for
logical drive <logical drive number> on Smart Array controller <controller
name / slot information>.
Message Id: 24662
Severity: Informational
HPE Smart Array errors 191