153 A blade boot device can only be listed once.
154 NTP Poll time must be between 60 and 86400 seconds.
155 Could not create new file.
156 Could not write the file to the disk.
157 The submitted image is too big.
158 The submitted image is not a BMP image.
159 The submitted image does not have the appropriate dimensions.
160 Non-standard BMP images are not supported.
161 The specified item was not found.
162 The protocol specified in the URL is not supported.
163 The upload to the specified URL failed.
164 The Onboard Administrator did not fail over.
165 The blade is in a powered off state.
167 The IP manager does not exist.
168 There is no SSH key installed.
169 There was a problem running the configuration script.
170 Missing credentials.
171 Caught the SIGSEGV signal.
173 No trap receivers were specified.
174 There are no SSH keys installed.
175 There was an error attempting to clear the SSH keys.
176 The IP address is already listed.
177 There was an error getting the SSO trust mode.
178 The submitted SSO trust mode is invalid.
179 The certificate cannot be removed because it does not exist.
180 The interconnect tray is not present.
181 The blade is not present.
182 Users cannot remove or disable themselves.
183 Invalid time zone.
184 Error setting CLP strings.
185 Error getting CLP status.
186 Error setting ISMIC info block.
187 Error reading ISMIC info block.
188 Error clearing blade signature.
189 Error setting blade signature.
190 Request is valid only for server blades.
191 Request is valid only for ProLiant server blades.
192 The string entered is not a valid netmask.
HPE Onboard Administrator errors 229
To Next Page
Loading...
