HPE ProLiant Gen9 - Page 277

Trap name Trap data Description
vcModInputErrorsDown
port identification
ifInErrors
The input error count on a port has
dropped below its low-water mark
for longer than the error averaging
period. port is the index of the
affected port in ifTable.
vcModOutputErrorsUp
port identification
ifOutErrors
The output error count on a port
has exceeded its high-water mark
for longer than the threshold
averaging period. port is the
index of the affected port in
ifTable.
vcModOutputErrorsDown
port identification
ifOutErrors
The output error count on a port
has dropped below its low-water
mark for longer than 30 seconds.
port is the index of the affected
port in ifTable.
vcModPortBpduLoopDetected
port identification
loop status
A network loop condition is
detected on this port. If the loop
condition is detected on a Flex10
port, the trap data indicates the
physical port associated with the
Flex10 port.
If multiple Flex10 ports on a
physical port detect a loop
condition, a separate trap is sent
for each occurrence of the loop
condition.
vcModPortBpduLoopCleared
port identification
loop status
A network loop condition is cleared
on this port. The trap data
indicates the physical port
associated with a Flex10 port.
For Flex10 ports, this trap is sent
only after all Flex10 ports on a
physical port are cleared from a
loop condition.
vcModPortProtectionConditionDet
ected
Port index to the ifTable (ifIndex)
Port index to the
vcModulePortTable
Port protection status
A port protection condition is
detected on this port. If the new
port protection status is a value
other than OK, the port may be
disabled to protect the VC module
from further service degradation.
Administrative action is required to
recover the port from this
condition.
Table Continued
HPE Virtual Connect errors 277