Log Severity: Warning (2)
Log Message: The %1 Agent is older than other components. The %1 Agent is older than the other
components of the Storage Agents. Reinstall the entire Storage Agents package to correct this error.
Event identifier: cpqstmsg.dll - 1800 (Hex) 0x84350708 (Service Event)
Log Severity: Warning (2)
Log Message: Unable to read security configuration information. SNMP sets have been disabled.
Cause: This can be caused by an invalid or missing configuration or by a corrupt registry. Reinstalling the
Storage Agents might correct this issue.
Event identifier: cpqstmsg.dll - 1803 (Hex) 0xc435070b (Service Event)
Log Severity: Error (3)
Log Message: Unable to load a required library. This error can be caused by a corrupt or missing file.
Reinstalling the Storage Agents or running the Emergency Repair procedure may correct this error.
Event identifier: cpqstmsg.dll - 1804 (Hex) 0x8435070c (Service Event)
Log Severity: Warning (2)
Log Message: The Storage SNMP Agent was unable to forward an SNMP trap to the Remote Insight Board
trap due to processing error. The data contains the error code.
Event identifier: cpqstmsg.dll - 1806 (Hex) 0x8435070e (Service Event)
Log Severity: Warning (2)
Log Message: The Storage Agent service is not running. The SNMP Agent has determined that the Storage
Agent service is not running. Stop the SNMP service and restart the Storage Agents service. If the error
persists, reinstalling the Storage Agents may correct this error.
Event identifier: cpqstmsg.dll - 1807 (Hex) 0x4435070f (Service Event)
Log Severity: Information (1)
Log Message: The Storage SNMP Agent has determined the Storage Agents service is running.
Event identifier: cpqstmsg.dll - 1808 (Hex) 0x44350710 (Service Event)
Log Severity: Information (1)
Log Message: The agent could not deliver trap %1. The agent was unable to use Asynchronous Management
to deliver a trap. This can be caused by a failure in the Remote Access Service or by a missing or invalid
configuration. Use the HPE Insight Management Agents control panel to verify the Asynchronous
Management configuration settings. Use the Network control panel to verify the Remote Access configuration.
If this error persists, reinstalling the Storage Agents or the Remote Access Service may correct this error. For
more information, see the Insight Asynchronous Management documentation.
Event identifier: cpqstmsg.dll - 3584 (Hex) 0x84350e00 (Service Event)
Log Severity: Warning (2)
Log Message: The IDE Agent could not allocate memory. The data contains the error code.
Event identifier: cpqstmsg.dll - 3585 (Hex) 0x84350e01 (Service Event)
Log Severity: Warning (2)
Log Message: The IDE Agent could not open the base of the registry. The data contains the error code.
Event identifier: cpqstmsg.dll - 3586 (Hex) 0x84350e02 (Service Event)
Log Severity: Warning (2)
Log Message: “%1”. The data contains the error code.
Event identifier: cpqstmsg.dll - 3587 (Hex) 0x84350e03 (Service Event)
HPE Insight Management Agents for Servers for Windows 393
To Next Page
Loading...
