09/01/13www.HandiQuilter.com Sengs Menu | 8.3
Control how Pro-Stcher performs e-os
By eing o at the beginning and ending of stching, the stches will be secure and will not come undone.
The Tie O feature enables you to select your preferred method for how and when Pro-Stcher performs
e-os.
• Select Sengs, Tie O.
To have Pro-Stcher perform a e-o at the beginning of stching
• Select Tie-O Start.
To have Pro-Stcher perform a e-o at the end of stching
• Select Tie-O End.
To indicate how many e-o stches Pro-Stcher will perform
• Press the Tie-O # Plus Sign (+) to increase or Minus Sign (–) to decrease the number of e-o
stches Pro-Stcher performs. Alternately, touch the number box and type a value directly and
press Enter.
NOTE: The number you specify is the number of full stches that are formed, not the number
of mes the needles cycles. For example, if the e-o number is set to 2 and you selected the
Micro method, the needle cycles three mes before beginning to stch the design. Alternately, if
you selected the Tack method, the needle cycles ve mes to form two stches forward and two
stches back.
To set the length of each e-o stch
• Press the Distance Plus Sign (+) to increase or Minus Sign (–) to decrease the distance in inches for
each e-o stch. Alternately, touch the number box and type a value directly and press Enter.
Specify how many e-
o stches are done.
Specify the length
of e-o stches in
inches.
Choose either the Tack
or Micro method of
e-o.
Select Tie-O End to
perform a e-o at
the end of each seg-
ment in the design.
Select Tie-O Start to
perform a e-o at
the beginning of each
segment in the design.
!
To Next Page
Loading...
Need help?
General