HQ Pro-sTitcher - Tie-Off, Pull-up, and Pause Settings

09/01/13www.HandiQuilter.com Quilt Menu | 7.7
• Choose Tie-O Start or Tie-O End to indicate your preference for eos. Choose whether to use a
tacking stch or micro stches for the eos. If you do not select either eo opon, you will need
to manually do the eos.
To change the thread pullup sengs while quilng
Indicate how to pull up the bobbin thread before quilng a design. Pull-up On brings up the bobbin thread
and disables the motors for you to move the machine and pull up the bobbin thread. Pull-up Auto brings
up the bobbin thread and then automacally moves the machine aside and pauses for you to grab the
threads. In each case, press Resume to connue aer grabbing the threads. For more informaon about
the pullup opons, see Control how Pro-Stcher handles bobbin-thread pullups in chapter 8, Sengs
Menu.
• Choose Pull-up On or Pull-up Auto to indicate your preference for handling pullups. If you do not
select either pullup opon, you will need to manually pull up the bobbin thread before stching.
To change the pause delay sengs while quilng
Aer beginning to stch and following a pullup, Pro-Stcher does some stches and then pauses for you
to cut the threads. The pause delay seng indicates how much stching to do, measured in either inches
or seconds, before pausing. For more informaon about the pause delay opons, see Control the delay
following a bobbin-thread pullup in chapter 8, Sengs Menu.
Select to e o at the
end of stching.
Select to e o at the
beginning of stching.
Choose whether to
e o with a tacking
stch or with micro
stches.