To Next Page

To Previous Page

09/01/13www.HandiQuilter.com Installaon | 3.13

To aach the tablet computer

1. Disconnect the front handlebar cable from the side of the machine’s head. Then remove the

handlebars from the front of the quilng machine by removing the three hex-head bolts with a 5mm

Allen wrench.

If you’re having diculty reaching the front handlebar cable, rst remove two of the hex-head

bolts and loosen the third bolt. Then, rotate the handlebar slightly to provide easier access to the

handlebar cable.

2. Make sure the three handlebar bolts are in the front

handlebar and protruding out the boom of the

handlebar.

3. Posion the handlebar over the computer bracket

such that the screws go through the three holes in

the bracket.

4. Secure the handlebar and bracket in place on the machine head using the three handlebar bolts.

Questions and Answers:

Need help?

Do you have a question about the HQ Pro-sTitcher and is the answer not in the manual?

HQ Pro-sTitcher Specifications

General