HQ Pro-sTitcher - Reposition Menu; To Position a Design to the Intersection of the Crosshairs

09/01/135.32 | Design Menu www.HandiQuilter.com
Reposion Menu
The main way to reposion a design for quilng is to create an area based on your quilt and then to use
the Reposion or Skew/Align tools to posion the design relave to that area. However, you can use the
reposion funcons even if you haven’t dened an area.
NOTE: You can’t use the Skew and Align funcons with the Reposion funcons. For example, if
you skew a design to a dened area and then select one of the reposion opons, the Skew/Align
sengs are turned o (essenally reseng the design to its original shape) and the reposion
acon takes place.
Machine Quilting Tip: To quilt a skewed design multiple times
If you want to stch a skewed design mulple mes on the quilt, baseline the design (select
the Baseline buon in the lower right corner of the screen) and then reposion the design.
To posion a design to the intersecon of the crosshairs
• Move the quilng machine needle to a posion on the quilt where the design is to be quilted. If you
posioned the needle at the top-le corner, press the top-le corner buon. Pro-Stcher aligns the
top-le corner of the design with the posion of the needle and crosshairs. The boom-le corner,
top-right corner, and boom-right corner buons work the same way.
Posions top-le corner of the
design at the intersecon of the
crosshairs.
Centers the design
at the current needle
and crosshair
posion.
Reposions a design
relave to the Home
locaon.
The four corner
posioning buons
posion a design
relave to the
crosshairs.
!