HQ Pro-sTitcher - To Turn on Automatic Bobbin-Thread Pullups; Control the Delay Following a Bobbin-Thread Pullup; To Set the Pause Delay; To Set Pause Delay in Seconds

09/01/13www.HandiQuilter.com Sengs Menu | 8.5
To turn on automac bobbin-thread pullups
• Press Pull-Up Auto for Pro-Stcher to shi the quilng machine to the right a few inches aer
pulling up the bobbin thread so you can grab both threads. Press Resume to connue quilng the
design.
NOTE: If Pull-Up Auto is not selected, but Pull-Up On is selected, the quilng machine will take a
stch at the start point and then disable the motors. This enables you to manually push the quilng
machine aside to pull up the bobbin thread. Press Resume for the machine to move back into
posion and resume quilng.
Control the delay following a bobbin-thread pullup
The Pause Delay feature pauses the quilng machine shortly aer starng into a design and aer each me
a pullup is performed. This enables you to safely trim the thread tails.
• Select Sengs, Pause Delay.
To set the Pause Delay
• Select On to turn on Pause Delay or O to turn o Pause Delay.
You have the opon of seng the Pause Delay in seconds (how long of a delay) or inches (how far it
stches before pausing).
To set Pause Delay in seconds
• Select Seconds and then press the Plus Sign (+) to increase or Minus Sign (–) to decrease the
number of seconds for the pause. Pro-Stcher will pause the number of seconds indicated so you
can trim thread tails and then resume stching.
To set Pause Delay in inches
• Select Inches and then press Plus Sign (+) to increase or Minus Sign (–) to decrease the number of
inches Pro-Stcher stches before pausing. Press Resume aer trimming thread tails to connue
stching.
!