HQ Pro-sTitcher - Getting Started with HQ Pro-Stitcher; To Move the Quilting Machine after the Software Has Been Loaded; To Use the USB Flash Drive

09/01/13www.HandiQuilter.com Installaon | 3.31
Geng started with HQ Pro-Stcher
To move the quilng machine aer the soware has been loaded
• To move the quilng machine aer the soware has loaded, the motors should be disengaged.
Press the Disable Motors buon in the upper-right corner of the screen to disengage the motors.
Note that the buon changes to say Enable Motors.
If you have the EZ Carriage, use the opons on the Freehand screen to alternate between computerized
quilng and free-moon quilng.
• Choose Design, then Freehand. Select the Free Moon buon. Pro-Stcher automacally raises the
quick-release levers to disengage the carriage gears from the Flexirack. Select the Engaged
buon to once again use Pro-Stcher for computerized quilng.
If you have a carriage with levers
IMPORTANT: If you have a carriage with levers, you will need to manually raise the levers for
free-moon quilng and lower the levers for computerized quilng with Pro-Stcher.
To use the USB ash drive
• A USB ash drive is included with the Pro-Stcher and is pre-loaded with more than 180 designs.
These designs have also been loaded to the drive on the tablet computer, so the USB ash drive is
the backup copy of the designs.
Move the levers to the
down posion to use
Pro-Stcher.
When the carriage
levers are up (pictured),
the carriage gears are
disengaged from the
Flexiracks. Do this for
free-moon quilng.
Ü