www.HandiQuilter.com 09/01/13 Warranty/Training Checklist | 10.7
HQ Pro- Stcher Training Checklist
Customer Name Date of Purchase
HQ Representative Shop Name Date of Training
Signature of Owner Signature of Trainer
Note to the HQ Rep: Upon compleon, please cut along doed line and fax the signed copy to
Handi Quilter at 801-294-3011. It is okay to photocopy this page.
Installaon and Set Up
• Rack System ☐
• Carriage System ☐
• Encoder Cables ☐
• Gears Engage in Racks ☐
• Quick Release Mechanism ☐
HQ Pro-Stcher Overview
• Disable/Enable Motors ☐
• Pull-up Bobbin Thread ☐
• Zoom/Pan Funcon ☐
• Refresh ☐
• Half-Stch ☐
• Reset Home ☐
• Follow ☐
Design Menu
• Find drive where designs are
located ☐
• Show File with all Designs ☐
• Load Design ☐
• Design ☐
• Box ☐
• Jump Points ☐
• Start/Stop ☐
• Undo ☐
• Redo ☐
• History ☐
• Baseline ☐
• Loading and Saving a Design ☐
• Seng an Area ☐
• Rotaon (Mirror, Flip, 2-Point,
Group) ☐
• Crop (Inside, Outside, Open,
Closed) ☐
• Repeat ☐
• Resize ☐
• Skew and Align ☐
• Freehand Record and Mark ☐
• Reposion (by Corner,
Center, Start, End, Drag &
Drop, Nudge) ☐
Art & Stch (if applicable)
• Creang a Design ☐
• Saving a Design ☐
• Loading a Design from outside
source ☐
• Passing a Design back and
forth from Pro-Stcher ☐
Quilt Menu
• New Start/End Points ☐
• Jump Points ☐
• Move (Connuous & Stch) ☐
• Channel Lock ☐
• Trace Outline ☐
• Box ☐
• Area ☐
• Pause ☐
• Emergency Stop ☐
Sengs Menu
• Speed ☐
• Auto Jump ☐
• Stches-Per-Inch ☐
• Tie O (Tack and Micro) ☐
• Pullup ☐
• Pause Delay ☐
• Switch to Handlebar Control ☐
• Reconnect Motors ☐
• Reconnect Machine ☐
• Shut Down (Shutdown, Re-
boot, Exit to Windows) ☐
Cleaning and Maintenance
• Cleaning Rack ☐
• Maintenance of HQ
Machine ☐
Warranty Review
• Review Manufacturer’s
Warranty ☐
• Sign Checklist ☐
The items listed above have been explained to
me by my HQ Rep.
I have covered the items listed above with my
customer.
To Next Page
Loading...
Need help?
General