Huawei quidway s7700 - Configuring Manual VPN FRR

Data Preparation
To configure the VPN FRR, you need the following data.
No. Data
1 (Optional) Name of the routing policy
2 Name of the VPN instance
3 (Optional) Backup next hop
3.12.2 Configuring Manual VPN FRR
After a backup next hop (a PE) is specified according to the routing policy, the VPN traffic can
be forwarded to the backup next hop if traffic forwarding between PEs fails.
Context
Do as follows on the switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
route-policy route-policy-name { permit | deny } node node
The routing policy node is created and the routing policy view is displayed.
Step 3 Run:
apply backup-nexthop { ip-address | auto }
The backup next hop is configured.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 6 Run:
vpn frr route-policy route-policy-name
The VPN FRR is enabled.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 3 BGP MPLS IP VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
149