Huawei quidway s7700 - Example for Configuring Dynamic Vlls to Access a VPLS Network

7.13.6 Example for Configuring Dynamic VLLs to Access a VPLS
Network
Networking Requirements
As shown in Figure 7-17, VLLs are set up between UPEs and SPEs in Martini mode. CE1 and
CE2 access the full-meshed VPLS network through UPEs.
Figure 7-17 Networking of VPLS access through the dynamic VLL
CE1 CE2
UPE2UPE1
SPE1 SPE2
P
GE1/0/0
VLANIF50
10.1.1.1/24
GE1/0/0
GE1/0/0
VLANIF 60
GE1/0/0
VLANIF 60
10.1.1.2/24
GE2/0/0
VLANIF 30
100.1.3.2/24
GE2/0/0
VLANIF 30
100.1.3.1/24
GE1/0/0
VLANIF 10
100.1.1.1/24
GE1/0/0
VLANIF 10
100.1.1.2/24
GE1/0/0
VLANIF 20
100.1.2.2/24
GE2/0/0
VLANIF 20
100.1.2.1/24
GE2/0/0
VLANIF 40
100.1.4.1/24
GE2/0/0
VLANIF 40
100.1.4.2/24
Loopback1
1.1.1.9
Loopback1
2.2.2.9
Loopback1
3.3.3.9
Loopback1
4.4.4.9
Loopback1
5.5.5.9
VLANIF 50
Device Interface VLANIF interface IP address
SPE1 GigabitEthernet1/0/0 VLANIF 10 100.1.1.1/24
GigabitEthernet2/0/0 VLANIF 30 100.1.3.1/24
Loopback1 - 1.1.1.9/32
SPE2 GigabitEthernet1/0/0 VLANIF 20 100.1.2.2/24
GigabitEthernet2/0/0 VLANIF 40 100.1.4.1/24
loopback1 - 2.2.2.9/32
UPE1 GigabitEthernet1/0/0 VLANIF 50 -
GigabitEthernet2/0/0 VLANIF 30 100.1.3.2/24
Loopback1 - 4.4.4.9/32
UPE2 GigabitEthernet1/0/0 VLANIF 60 -
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
772