3.15.3 Configuring the RR to Establish MP IBGP Connections with
All Client CEs
This part describes how to configure MP-IBGP connections between the RR and all its clients
(CEs) to reflect VPNv4 routes to all clients (CEs).
Context
Do as follows on the RR:
Procedure
l Establishing the MP-IBGP Connection with the Peer Group
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed.
4. Run:
group group-name [ internal ]
An IBGP peer group is created.
5. Run:
peer group-name connect-interface interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
6. Run:
peer ip-address groupgroup-name
The peer is added to the peer group.
l Establishing the MP-IBGP Connection with Each Peer
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed.
4. Run:
peer ipv4-address as-number as-number
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 3 BGP MPLS IP VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
167
To Next Page
Loading...
