Huawei quidway s7700 - Configuring MP-IBGP between Pes

Context
Do as follows on the PE devices connected with CE devices.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the interface that is to be bound with the IPv6 VPN instance is displayed.
You can bind VLANIF interfaces to IPv6 VPN instances.
Step 3 Run:
ipv6 enable
The IPv6 capability is enabled on the interface.
Step 4 Run:
ipv6 binding vpn6-instance vpn6-instance-name
The interface is bound with the IPv6 VPN instance.
NOTE
Running the ipv6 binding vpn6-instance command deletes the Layer 3 features such as IPv6 address and
IPv6 routing protocols. They need to be re-configured if required.
Step 5 Run:
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
The IPv6 address is configured.
----End
4.4.4 Configuring MP-IBGP Between PEs
With extended community attributes added to BGP, MP-IBGP can advertise VPNv6 routes
between PEs.
Context
Do as follows on the PE devices connected with CE devices.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
331