Huawei quidway s7700 - Example for Configuring an SVC VLL

port hybrid pvid vlan 40
port hybrid tagged vlan 40
#
#
ccc CE2-CE1 interface Vlanif 40 in-label 201 out-label 101 nexthop 10.2.2.2
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 40
#
interface Vlanif 40
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 40
#
return
5.11.3 Example for Configuring an SVC VLL
Networking Requirements
The CE is connected to the PE through a GE interface.
An SVC VLL is set up between CE1 and CE2. The SVC connection is created on PEs and the
VC label is specified.
Figure 5-6 Networking diagram for configuring SVC VLL
GE 2/0/0 GE 2/0/0 GE 1/0/0 GE 1/0/0
GE 1/0/0 GE 2/0/0
GE 1/0/0
GE 1/0/0
P
PE 2PE 1
CE 1 CE 2
Loopback 1
1.1.1.9/32
Loopback 1
3.3.3.9/32
Loopback 1
2.2.2.9/32
SVC
connection
Device
Interface VLANIF interface IP address
PE1 GigabitEthernet1/0/0 VLANIF 10 -
GigabitEthernet2/0/0 VLANIF 20 10.1.1.1/24
Loopback1 - 1.1.1.9/32
PE2 GigabitEthernet1/0/0 VLANIF 30 10.2.2.1/24
GigabitEthernet2/0/0 VLANIF 40 -
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
499