EasyManua.ls Logo

Huawei quidway s7700 - Configuring Kompella VLL; Establishing the Configuration Task

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<Quidway> display mpls l2vc
total LDP VC : 1 1 up 0 down
*client interface : Vlanif1111
Administrator PW : no
session state : up
AC status : up
VC state : up
VC ID : 101
VC type : VLAN
destination : 3.3.3.9
local VC label : 23552 remote VC label : 23552
control word : disable
forwarding entry : existent
local group ID : 0
manual fault : not set
active state : active
link state : up
local VC MTU : 1500 remote VC MTU : 1500
tunnel policy name : --
traffic behavior name: --
PW template name : --
primary or secondary : primary
create time : 0 days, 0 hours, 6 minutes, 48 seconds
up time : 0 days, 0 hours, 5 minutes, 9 seconds
last change time : 0 days, 0 hours, 5 minutes, 9 seconds
VC last up time : 2010-07-24 12:31:31
VC total up time : 0 days, 2 hours, 12 minutes, 51 seconds
CKey : 16
NKey : 15
AdminPw interface : --
AdminPw link state : --
Run the display mpls l2vc remote-info command. You can find that the peer address is the peer
address of the specified VC. For example:
<Quidway> display mpls l2vc remote-info
Total remote ldp vc : 1
Transport Group Peer Remote Remote C MTU/ N S
VC ID ID Addr Encap VC Label Bit CELLS Bit Bit
101 0 3.3.3.9 vlan 2355223552 0 1500 0 0
5.6 Configuring Kompella VLL
This section describes how to configure a Kompella VLL. To configure the Kompella VLL, you
need to establish the Kompella VLL on the MPLS network in end-to-end (CE-to-CE) mode, and
use the Border Gateway Protocol (BGP) to transmit Layer 2 information and VC labels.
5.6.1 Establishing the Configuration Task
Before configuring a Kompella VLL, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The Kompella VLL uses BGP as the signaling protocol to transfer L2VPN information between
PEs.
Similar to BGP/MPLS VPN, Kompella mode uses the VPN target to control the receiving and
sending of the VPN routes. This brings about great flexibility.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
464

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals