l Configuring the LSR ID on the PE and the P and enabling MPLS
l Enabling MPLS L2VPN on the PE
l Establishing the tunnel between the PEs to transmit user data
Data Preparation
To configure Kompella VPLS, you need the following data.
No. Data
1 BGP peer to exchange VPLS information
2 VSI name
3 RD and VPN target of VSI
4 CE ID of the site, the number of CEs allowed to access VPLS, and default offset
value of the CE ID
5 Binding interface of the VSI
7.3.2 Enabling the BGP Peer to Exchange VPLS Information
BGP VPLS shares the TCP connection with the common BGP protocol. Therefore, most BGP
VPLS configurations are the same as the configurations of the common BGP protocol.
Nevertheless, VPLS label blocks need to be exchanged in BGP VPLS. Therefore, you need to
enable peers to exchange VPLS label blocks in the BGP VPLS sub-address family view.
Context
NOTE
For details of commands in BGP VPLS address family view, refer to the chapter "IP Routing Commands"
in the Quidway S7700 Smart Routing Switch Command Reference.
Do as follows on the PEs of the two ends of the PW:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The BGP peer is configured.
Step 4 (Optional) Run:
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
682
To Next Page
Loading...
