EasyManua.ls Logo

Huawei quidway s7700 - Maintaining a VPN Tunnel; Monitoring the Running Status of a Tunnel

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AC status : up
VC state : up
VC ID : 116119
VC type : VLAN
destination : 6.6.6.6
local VC label : 23552 remote VC label : 23552
control word : disable
forwarding entry : exist
local group ID : 0
manual fault : not set
active state : active
link state : up
local VC MTU : 1500 remote VC MTU : 1500
tunnel policy name : policy1
traffic behavior name: --
PW template name : --
primary or secondary : primary
create time : 0 days, 0 hours, 3 minutes, 45 seconds
up time : 0 days, 0 hours, 3 minutes, 45 seconds
last change time : 0 days, 0 hours, 3 minutes, 45 seconds
VC last up time : 2007/09/20 20:33:37
VC total up time : 0 days, 0 hours, 3 minutes, 45 seconds
CKey : 5
NKey : 4
AdminPw interface : --
AdminPw link state : --
1.8 Maintaining a VPN Tunnel
Monitor the running status of the VPN tunnel.
1.8.1 Monitoring the Running Status of a Tunnel
To know whether a VPN tunnel is created and configurations of a created tunnel, you can monitor
the running status of the VPN tunnel.
Context
In routine maintenance, you can run the following commands to view the running status of a
VPN tunnel.
Procedure
l Run the display interface tunnel interface-number command to view information about
the tunnel interface.
l Run the display tunnel-info tunnel-id command to view information about a specified
tunnel.
l Run the display tunnel-info all command to view information about all tunnels.
l Run the display tunnel-policy tunnel-policy-name command to view information about a
specified tunnel policy.
l Run the display ip vpn-instance verbose [ vpn-instance-name ] command to view
information about the tunnel policy oused by a specified VPN instance.
l Run the display ip routing-table vpn-instance [ ip-address ] verbose command to view
information about the tunnel for IP routing.
l Run the display mpls l2vc [ interface interface-type interface-number ] command to view
information about the tunnel used by the VC in the SVC, PWE3 VC, or Martini L2VPN.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals