Huawei quidway s7700 - Example for Configuring Static Vlls to Access a VPLS Network

#
return
7.13.5 Example for Configuring Static VLLs to Access a VPLS
Network
Networking Requirements
As shown in Figure 7-16, UPEs do not support dynamic VLLs, and access SPEs through static
VLLs; VLLs are set up between UPEs and SPEs in SVC mode; CE1 and CE2 access the VPLS
fully-connected VPLS network through UPEs.
Figure 7-16 Networking diagram for configuring static VLLs to access a VPLS network
Loopback1
5.5.5.9/32
UPE1 UPE2
P
Loopback1
4.4.4.9/32
GE1/0/0
GE2/0/0
GE2/0/0
GE1/0/0
Loopback1
SPE1
SPE2
1.1.1.9/32
Loopback1
2.2.2.9/32
Loopback1
3.3.3.9/32
GE1/0/0
GE1/0/0
GE2/0/0
GE1/0/0
GE1/0/0
CE1
CE2
GE1/0/0
GE2/0/0
GE2/0/0
Device
Interface VLANIF Interface IP Address
UPE1 GigabitEthernet 1/0/0 VLANIF 20 100.1.3.2/24
GigabitEthernet 2/0/0 VLANIF 10 -
Loopback1 - 4.4.4.9/32
SPE1 GigabitEthernet 1/0/0 VLANIF 30 100.1.1.1/24
GigabitEthernet 2/0/0 VLANIF 20 100.1.3.1/24
Loopback1 - 1.1.1.9/32
P GigabitEthernet 1/0/0 VLANIF 30 100.1.1.2/24
GigabitEthernet 2/0/0 VLANIF 40 100.1.2.1/24
Loopback1 - 2.2.2.9/32
SPE2 GigabitEthernet 1/0/0 VLANIF 40 100.1.2.2/24
GigabitEthernet 2/0/0 VLANIF 50 100.1.4.1/24
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
761