The VSI view is created and the static member discovery is enabled.
Step 3 Run:
pwsignal ldp
The LDP is specified as the PW signaling protocol and the VSI LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The VSI ID is configured.
Step 5 Run:
mac-withdraw enable
After the configuration, when an AC fault or a UPE fault occurs and the VSI remains Up, the
local MAC address is deleted and all the remote peers are informed of the deletion.
This command takes effect only after the interface-status-change mac-withdraw enable
command is also used.
Step 6 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
The VSI peer is configured.
Step 7 Run:
peer peer-address [ tnl-policy policy-name ] static-upe trans transmit-label recv
receive-label
The received and sent labels between the SPE and the static UPE are configured.
The label trans here must be the same as the label receive-vpn-label that is configured on UPE.
In addition, the label recv must be the same as the label transmit-vpn-label that is configured
on UPE.
----End
7.6.5 Checking the Configuration
After configuring a static VLL to access the VPLS network, you can view information about
SVCs, interfaces of the SVCs that are in the Up state, local VSIs, remote VSIs, VPLS
connections, and dynamic MAC address entries.
Prerequisite
The configurations of the Static VLL to Access the VPLS Network function are complete.
Procedure
l Run the display mpls static-l2vc [ interface interface-type interface-number ] command
to check information about the L2VPN connection in SVC mode.
l Run the display l2vpn ccc-interface vc-type static-vc up command to check information
about the SVC interface in the Up state.
l Run the display vsi [ name vsi-name ] [ verbose ] command to check information about
the VSI of the VPLS.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
703
To Next Page
Loading...
